Related Manuals for Bellfires Room Divider Medium 3 CF
Summary of Contents for Bellfires Room Divider Medium 3 CF
- Page 1 U U ser manual Room Divider Medium 3 CF/LF/MF Room Divider Medium 3 L/R CF/LF/MF Serial number: Production date:...
- Page 2 Barbas Bellfires BV. This document could contain technical inaccuracies or typographical errors. Barbas Bellfires BV reserves the right to revise this document from time to time in the contents thereof.
-
Page 3: Table Of Contents
Contents C C ontents About this document................5 How to work with this document....................5 Warnings and cautions used in this document................5 Related documentation........................ 5 Description....................6 Intended use..........................6 Overview of the appliance......................6 Overview of the remote control....................7 2.3.1 Overview of the buttons.................... - Page 4 Contents Maintenance..................22 Maintenance schedule....................... 22 Clean the appliance........................22 Clean the glass.......................... 22 5.3.1 Cleaning instructions for anti-reflective glass..............22 5.3.2 Cleaning instructions for standard glass................. 23 Troubleshooting..................24 Troubleshooting table........................ 24 Troubleshooting procedures...................... 24 6.2.1 Replace the batteries of the remote control..............24 Technical data..................26 Room Divider Medium 3 (L/R) CF (Centre Fire)................
-
Page 5: About This Document
About this document About this document This document shows the necessary information to do these tasks on the : • Operate the appliance • Do basic maintenance This document refers to the as 'the appliance'. This document is an essential part of your appliance. -
Page 6: Description
Description Description Intended use Only use the appliance to heat the room in which the appliance is installed. Do not use the appliance for a different purpose. Overview of the appliance Item Description Glass The heat resistant glass keeps the flue gas- ses inside the appliance and closes the com- bustion chamber off Burner bed... -
Page 7: Overview Of The Remote Control
Description I I tem Description Overpressure hatches Protects the appliance against an overpres- sure Operating unit Contains the gas regulator block, receiver and the light module Convection casing Collects the heated convection air. The con- vection air has a natural upward flow and is extracted by the upper front side openings of the appliance Extended feet holder... -
Page 8: Overview Of The Display
Description I I tem Description Burner To set the burner mode. Eco mode To set to eco mode. Down To set different options. Fan (Not applicable) To set to fan mode Light (only for MF burner) To set to light mode 2.3.2 Overview of the display Item... -
Page 9: Operation Modes
Description I I tem Description Light symbol (only for MF To show that the light is on burner) Operation modes 2.4.1 Thermostatic mode In this mode the appliance measures the room temperature and compares this to the set temperature. The appliance automatically adjusts the flame height to make sure that the room temperature agrees with the set temperature. -
Page 10: Overview Of The Control Elements
Connection for a wifi-box (SI) Optionally, a wifi-box can be connected to the receiver to control the appliance with a smart- phone or tablet with the Bellfires app Connection for the light module (MODULE) To control the light function (only for MF burner) -
Page 11: Overview Of The Light Module (Mf Only)
Description 2 2 .5.2 Overview of the light module (MF only) Item Description Connection for the ambient lights Powers the ambient light bulbs Auxiliary connection Not used connection for the power supply Connection for the 230 VAC power cable with an earthed plug. -
Page 12: Safety
Make sure that the appliance is installed correctly. Refer to the Installation http:// and Maintenance manual. You can find the manuals on bellfires.com • Make sure that the appliance is installed and connected as a 'room sealed system' appliance by a certified and registered gas installation engineer. -
Page 13: Safety Instructions With Regard To The Environment
Safety 3 3 .3 Safety instructions with regard to the environment • Dispose of the packing materials in an environmentally friendly way. • Dispose of batteries as chemical waste. • Dispose of ceramic heat-resistant glass as household waste. Do not dispose of ceramic heat-resistant glass in a glass recycling container. -
Page 14: Operation
Operation Operation Preparation before first use 4.1.1 Do a check on the appliance Make sure that the appliance is not damaged. Make sure that the glass is not damaged. Make sure that the pilot light operates correctly. 4.1.2 Prepare the appliance Warning: •... -
Page 15: Set The Remote Control Settings
Operation N N ote: • The main burner burns at maximal height after start-up. • If the pilot light goes out and you start the appliance too early, the remote control will start but the fire will not burn. Restart the remote control. •... -
Page 16: Operate The Appliance
Operation 4 4 .3 Operate the appliance 4.3.1 Operate the appliance Table 1: Start and stop the appliance Action Preconditions Steps Result Start the appliance The remote control is • You hear a short with one-button opera- set to the one-button Push beep. - Page 17 Operation A A ction Preconditions Steps Result Stop the child proof mode Push at the same time Start the thermostatic mode Push Stop the thermostatic mode Push Start the program mode Push Stop the program mode Push Start the eco mode Push Stop the eco mode Push...
- Page 18 Operation A A ction Preconditions Steps Result Start the rear burner Push Stop the rear burner Push Table 4: Adjust the flame height Note: When you start the appliance the flame height is automatically set to maximum. Action Preconditions Steps Result Decrease the flame height...
- Page 19 Operation A A ction Preconditions Steps Result Start the light Possible when the fire is on or off. Push Stop the light Push Decrease the light The light symbol is on. • Push and hold brightness until the light symbol flash- •...
-
Page 20: Change The Settings
Operation 4 4 .4 Change the settings 4.4.1 Set the temperature for the thermostatic mode Push and hold the thermostatic mode button until the thermostatic mode symbol appears and the temperature flashes. Use the up and down buttons to set the temperature. Push the thermostatic mode button to store the temperature or wait until the temperature stops to flash. -
Page 21: Set The Countdown Timer Mode
Operation 12. If you want program 2 active, push the program mode button and set the on and off time for program 2. 13. Wait for the blinking to stop to save the settings. 4 4 .4.3 Set the countdown timer mode Note: The maximum period of time you can set for this mode is 9 hours and 50 minutes. -
Page 22: Maintenance
Maintenance Maintenance Maintenance schedule Caution: Clean the glass when it is dirty. If the glass is not cleaned when it is dirty the glass can become permanently dull. Task Frequency Procedure Clean the appliance Daily Refer to section Maintenance by your fitter Yearly Refer to your fitter/dealer Clean the appliance... -
Page 23: Cleaning Instructions For Standard Glass
Maintenance 5 5 .3.2 Cleaning instructions for standard glass Use gloves to prevent fingerprints on the glass. Clean the glass with a soft cloth, a sponge or tissue paper. Use glas cleaner or ceramic hob cleaner. Make sure the glass is dry. Water droplets can leave a mark on the glass. Room divider Medium 3... -
Page 24: Troubleshooting
Troubleshooting Troubleshooting Troubleshooting table Problem Possible cause Possible solution The pilot light does not come • Close the gas supply on after three attempts. • Contact your fitter. The burner does not operate within 10 seconds of firing the pilot light. When the burner starts you hear a 'boom' sound. - Page 25 Troubleshooting Remove the cover of the remote control. Remove all batteries. Install new batteries. For approved batteries, refer to section Close the cover of the remote control. Room divider Medium 3...
-
Page 26: Technical Data
Room Divider Medium 3 (L/R) CF (Centre Fire) Natural gas/ Bio-methane Butane/ Propane/ Bio-propane Name Bellfires Bellfires Model Room Divider Medium 3 CF Room Divider Medium 3 CF Room Divider Medium 3 L/R Room Divider Medium 3 L/R Country GB, IE, ES, IT GB, IE, ES, IT... -
Page 27: Room Divider Medium 3 (L/R) Lf (Line Fire)
Heat changing surface: Entire front of the appliance. Room Divider Medium 3 (L/R) LF (Line Fire) Natural gas/ Bio-methane Butane/ Propane/ Bio-propane Name Bellfires Bellfires Model Room Divider Medium 3 LF Room Divider Medium 3 LF Room Divider Medium 3 L/R LF... -
Page 28: Room Divider Medium 3 (L/R) Mf (Magnifire)
Heat changing surface: Entire front of the appliance. Room Divider Medium 3 (L/R) MF (MagniFire) Natural gas/ Bio-methane Butane/ Propane/ Bio-propane Name Bellfires Bellfires Model Room Divider Medium 3 MF Room Divider Medium 3 MF Room Divider Medium 3 L/R... - Page 29 Technical data N N atural gas/ Bio-methane Butane/ Propane/ Bio-propane Useful efficiency (Net Calorific 91.8 % 92.0 % Value (NCV)) at nominal heat output Useful efficiency (Net Calorific 86.8% 87.0 % Value (NCV)) at minimum heat output (indicative) (max.) (Gross Calorific <130 mg/kWh <130 mg/kWh input...
-
Page 30: Warranty Terms
Complaints will only be accepted if they are reported to the Bellfires dealer, together with the serial number of the Bellfires appliance which is stated on the front of the user manual. In addition, the original receipt (invoice, receipt, cash receipt) showing the date of purchase must also be submitted. - Page 31 Article 5: Warranty period This warranty will only be granted during the warranty period. The body of the Bellfires appliance is guaranteed for a period of 10 years against construction and/or material faults, starting from the moment of purchase. For other parts of the Bellfires appliance, a similar warranty applies from the moment of purchase for a period of two years.
-
Page 32: Eu-Declaration Of Conformity
EU-Declaration of Conformity EU-Declaration of Conformity Room divider Medium 3... - Page 33 EU-Declaration of Conformity Room divider Medium 3 3 3 3...
- Page 34 EU-Declaration of Conformity 3 3 4 Room divider Medium 3...
- Page 35 EU-Declaration of Conformity Room divider Medium 3 3 3 5...
- Page 36 Y Y our Bellfires dealer 001 - 14.06.2019 - 348717...