Jet M-708639M/T Operating Instructions Manual page 5

Collector Housing:
Attach 3 support brackets (A, Fig 4) to
the base using 6 hex cap screws (B)
and washers.
Fig 4
Install the housing (A, Fig 5) with 6 hex
cap screws (C).
Fig 5
Cone Assembly:
Mount the cone support bracket (I, Fig
6) to the housing with 4 hex cap
screws (J) and nuts.
Mount the cone (K) from beneath with
hex cap screw (H), washer and nut.
Fig 6
Hose Assembly:
Attach the hose (A, Fig 7) with 2
provided clamps (B).
Fig 7
Collector bag:
Fold the plastic bag over the top of the
snap ring (E, Fig 8).
Fig 8
Insert the snap ring (E) of the collector
bag into the bottom of the housing at
an angle. Pull down until it engages in
the grove (F, Fig 9)
Fig 9
Filter bag (DC-1100A):
Attach the bag support rods (A, B Fig
10).
Fig 10
Install the filter bag with retainer strap
(D).
Canister filter (DC-1100CK):
Mount the handle (I, Fig 11) with 2 hex
nuts (G), flat wasshers (H) and a lock
washer (J).
Fig 11
Mount the canister filter with 4 knobs
(K) on the collector housing.