Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Service Centers located throughout the United States can give you quick service. In most cases, any of these Walter Meier Authorized Service Centers can authorize warranty repair, assist you in obtaining parts, or perform routine maintenance and major repair on your JET tools.
Cleaning the Filter Bag – DC-1100BK and DC-1100MK ... 15 Removing the Collector Bag–DC-1100BK ... 15 Cleaning the Filter – DC-1100CK ... 15 Removing the Collector Bag–DC-1100CK and DC-1100MK ... 15 Motor ... 15 Connecting the Dust Collector to a Machine ... 15 Grounding the Dust Collection System ...
4. This dust collector is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a dust collector, do not use until proper training and knowledge have been obtained.
22. Do not use the dust collector for anything except wood dust. Materials such as liquids, metal shavings, metal dust, screws, glass, plastic or rock can cause sparks and/or damage when coming into contact with any part of the dust collector.
2. Check contents of each carton against the ship- ping content listings on this and the following page. 3. Report any damage to your distributor. 4. Do not discard any shipping material until after the dust collector has been assembled and is running properly. DC-1100BK DC-1100CK DC-1100MK Table –...
M8 x 16 hex cap screws, and M8 flat washers (B). Tighten with a 13mm wrench. The dust collector must not be connected to the power source during assembly. Failure to comply may result in serious injury! Referring to Figure 3: 4.
This completes the Base Unit assembly. If you purchased the DC-1100BK or DC-1100MK Dust Collector (filter bag versions), continue on the following page. If you purchased the DC-1100CK Dust Collector (canister filter version), proceed to Canister Kit Assembly section on page 12.
Filter Bag Kit Assembly If you purchased a DC-1100BK, or DC-1100MK Dust Collector, this section describes the assembly and installation of the contents of the Filter Bag Kit (SN 708636F or 708636MF). Filter Bag Installation Referring to Figure 7: 1. Place the hanger (A) on the hanger bracket (B). 2.
Canister Kit Assembly If you purchased Model DC-1100CK Dust Collector, this section describes the assembly and installation of the contents of the Canister Kit (SN 708639B). Canister Filter 1. Mount the handle onto the canister filter with two M10 hex nuts, two M10 flat washers, and a M10 lock washer (Figure 9).
A dedicated circuit to the dust collector will give you the best results since dust collectors are generally used at the same time other tools are running.
1. Place RC Power Control Unit (A) on the open clearing of the base (B) of the dust collector near the motor (C). 2. Using a marker, mark the base through the mounting holes of the power control units mounting tabs.
Collector Hoses and Accessories. Customize your installation and obtain maximum performance with JET dust hoods, hoses, clamps, fittings, and blast gates. Cleaning the Filter – DC-1100CK this machine before turning switch off and removing plug from power source. Failure to comply may cause serious injury!
Parts List – DC-1100 Dust Collectors Ordering Replacement Parts To order parts or reach our service department, call 800-274-6848, Monday through Friday (see our website for business hours, www.waltermeier.com). Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately.