Advertisement
Available languages
Available languages
Do not operate the machine under the
influence of drugs, alcohol or any
medication. Be aware that medication
can change your behaviour.
Keep children and visitors a safe
distance from the work area.
Never leave a running machine
unattended. Before you leave the
workplace switch off the unit.
Do not operate the electric tool near
inflammable liquids or gases.
Observe the fire fighting and fire alert
options, for example the fire
extinguisher operation and place.
Do not use the dust collector in a
dump environment and do not expose
it to rain.
Do not use this equipment to filter
volatile fumes or smoke.
Wood dust is explosive and can also
represent a risk to health.
Dust form some tropical woods in
particular, and from hardwoods like
beach and oak, is classified as a
carcinogenic substance.
Connection and repair work on the
electrical installation may be carried
out by a qualified electrician only.
Have a damaged or worn power cord
replaced immediately.
3.3 Remaining hazards
When using the machine according to
regulations some remaining hazards
may still exist.
Dust can cause injuries.
The use of incorrect mains supply or a
damaged power cord can lead to
injuries caused by electricity.
Danger of explosion if not properly
grounded.
4. Machine specifications
4.1 Technical data
Dust inlet
Ø 150mm (2xØ 100mm)
Air flow Ø 150
Air flow Ø 100
Vacuum pressure
Collector bag capacity
Overall DC-1100A:
(LxWxH)
940x510x2000mm
Net weight
Overall DC-1100CK:
(LxWxH)
940x510x1830mm
Net weight
Mains
Output power
Reference current
Extension cord (H05VV-F) 3Cx1.5mm²
Installation fuse protection
Mains
Output power
Reference current
Extension cord (H05VV-F) 4Cx1.5mm²
Installation fuse protection
4.2 Noise emission
Acoustic pressure level
(EN ISO 11202):
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Filter bag (DC-1100A)
Canister filter (DC-1100CK)
Mobile casters
Cone support bracket
Cone
Dust inlet 2 x 100 mm
Set of 5 collection bags
5. Assembly and start up
5.1 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the unit!
Dispose of the packing in an
environmentally friendly manner.
Base:
Install four casters to the under side of
the base with lock washer and nut (Fig
1)
1620 m³/h
1150 m³/h
1700Pa
200L
48 kg
71 kg
230V ~1/N/PE 50Hz
1,1kW (1,5HP) S1
4.8 A
10A
400V ~3L/PE 50Hz
1,1kW (1,5HP) S1
2 A
10A
LpA 80 dB(A).
Fig 1
Motor and fan assembly:
Attach the motor and fan assembly (A)
to the base, using 4 hex cap screws
(B) and flat washers.
Fig 2
Attach inlet guard (A, Fig 3) to fan
housing using 8 pan head screws (B).
Fig 3
Press the inlet port (C) and secure
with provided screw.
Attention:
To reduce the risk of injury from
moving parts, always keep inlet port
covered with the caps provided, if they
are not connected to a hose.
Advertisement
