Emerson Quantum MP QMP45A4 User Manual page 84

Safety Product Mechanical
Information Information Installation
This parameter gives the checksum of the data block, space left on the
card, the total space on the card or the card flags. Refer to Pr 11.37 for
information.
11.42
Parameter copying
(SE09, 0.30)
RW Txt NC

0 to 4
NOTE
* Mode 1 and Mode 2 are not saved when the drive parameters are
saved. This parameter can only be saved to EEPROM if it has a value of
0, 3 or 4.
Table 9-5 Pr 11.38 actions
Actions Value
None 0
Reading 1
Programming 2
Auto 3
Boot 4
84
Electrical Getting Basic Running the
Installation Started parameters
US*

0
Result
Inactive
Read parameter set from
SMARTCARD
Program parameter set to the
SMARTCARD
Auto save
Boot mode
SMARTCARD
Optimization
Motor Operation
www.emersonct.com
Onboard Advanced Technical
Diagnostics
PLC Parameters Data
Quantum MP User Guide
UL
Information
Issue: A3