Emerson Quantum MP QMP45A4 User Manual page 16

Safety Product Mechanical
Information Information Installation
3.3.3 Installation and removal of a Solutions Module
Please power down the drive before removing / installing the
Solutions Module. Failure to do so may cause damage to
product
CAUTION
Figure 3-3 Installation and removal of the Solutions Module - Size 1 shown
To install the Solutions Module in either a Quantum MP size 1 or size 2
drive, press down in the direction shown above until it clicks into place.
To remove the Solutions Module, press inwards at the points shown (A)
and pull in the direction shown (B).
The drive has the facility for all three Solutions Module slots to be used
at the same time, as illustrated. The SM-I/O 120V module needs to stay
in Slot 3.
NOTE
It is recommended that the Solutions Module slots are used in the
following order: slot 2 and slot 1.
16
Electrical Getting Basic
Installation Started parameters
Installing Solutions Module
Three Solutions Modules installed
Running the SMARTCARD
Optimization
Motor Operation
Removing Solutions Module
Solution Module
in slot 1
Solution Module
in slot 2
SM-I/O 120V Module
in slot 3
www.emersonct.com
Onboard Advanced Technical
Diagnostics
PLC Parameters Data
B
A
A
Quantum MP User Guide
UL
Information
Issue: A3