Fcc-Approved Antennas (2.4 Ghz) - Digi PS2CSM Product Manual

® ®
XBee /XBee‐PRO ZB RF Modules
IMPORTANT: The RF module has been certified for remote and base radio applications. If the module will
be used for portable applications, the device must undergo SAR testing.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures: Re-orient or relocate the receiving antenna, Increase the separation
between the equipment and receiver, Connect equipment and receiver to outlets on different circuits, or
Consult the dealer or an experienced radio/TV technician for help.

FCC-Approved Antennas (2.4 GHz)

The XBee and XBee-PRO ZB RF Modules can be installed utilizing antennas and cables constructed with
non-standard connectors (RPSMA, RPTNC, etc.) An adapter cable may be necessary to attach the XBee
connector to the antenna connector.
The modules are FCC approved for fixed base station and mobile applications for the channels indicated in
the tables below. If the antenna is mounted at least 20cm (8 in.) from nearby persons, the application is
considered a mobile application. Antennas not listed in the table must be tested to comply with FCC Section
15.203 (Unique Antenna Connectors) and Section 15.247 (Emissions).
XBee ZB RF Modules have been tested and approved for use with all the antennas listed in the tables below.
(Cable-loss IS required when using gain antennas as shown below.)
The antennas in the tables below have been approved for use with this module. Digi does not carry all of
these antenna variants. Contact Digi Sales for available antennas.
© 2014 Digi International Inc. 167