Cleaning And Care; General Information On Cleaning And Disinfection; Cleaning The Treatment Unit Surface - Atmos S 61 Servant Operating Instructions Manual

5.0 Cleaning and care

5.1 General information on cleaning and disinfection

Prior to cleaning:
Set the main switch of the ATMOS S 61 Servant ENT workstation to OFF prior to cleaning and disinfection!
Prior to each use:
) The described actions relating to cleaning and
disinfection or sterilization do not substitute the relevant
instructions that must be adhered to prior to operation!
• For disinfection, you may use all surface and instrument
disinfectants listed in the following subchapter
"Recommended disinfectants".
• Please ensure that no wet surfaces are left behind. Use a
disposable cloth to absorb any liquid.
• If any disinfectant is spilled, make sure to wipe the
surface dry immediately in order to prevent the liquid from
penetrating gaps and edges.

5.1.1 Cleaning the treatment unit surface

• The surfaces of the ATMOS S 61 Servant ENT
workstation are resistant to all surface disinfectants listed
in chapter "Recommended disinfectants."
• Wipe the treatment unit surface with a cloth moistened
with a cleaning or disinfecting solution.
• Disinfectant sprays or disinfectant tissues may also be
used for cleaning and disinfection.
ª Please observe that the alcohol contained in these
agents could corrode or cloud the protective covers if
employed on a long-term basis.
• Do not use any process chemicals that contain the
following ingredients on surfaces made of CORIAN
- Strong acids (e.g., concentrated sulfuric acid)
- Ketones (e.g., acetones)
- Solvents containing chlorine (e.g., chloroform)
- Strong solvent combinations (e.g., paint remover)
28
if
required
) Always observe the concentration specifications and
instructions by the respective manufacturer!
• Do not use
- Disinfectants that contain organic or inorganic acids
or bases, as they could cause corrosion damage.
- Disinfectants containing chloramides or phenol
derivatives, since these may cause stress cracks in
the plastic material used.
• All applied parts that are exposed to direct contact
with the patient during treatment must be exchanged
or cleaned and disinfected immediately for hygienic
reasons.
• Only deposit clean instruments on the shelves!
• Clean and disinfect the instruments regularly!
:
®