Electrical Installation
Electrical Installation
Remove the Electrical Access Panel (Detail B) to
Remove the front unit panel
expose the Incoming Power Terminal Block
to expose the incoming power
(Detail C, see below)
terminal block (Detail, see
below)
Ground
Ground
B
L1
L2
L1
L 2
Remove and discard hole knock-out from
the side of the unit (Detail A)
Remove and discard hole knock-out from the side
of the unit (Detail A)
Insert all wires through the
punched out hole and fasten
Insert all wires (Green, Black, Red) through the
wires.
punched out hole and fasten wires as follows:
Green to Ground
Black to L1
Red to L2
26