Sony DVCAM DSR-PDX10 Operating Instructions Manual page 30

Recording a picture
(3) Attach the wind screen to the microphone.
(4) Loosen the microphone holder screw and open the cover.
(5) Place the microphone into the holder with the model name (ECM-NV1) facing
(6) Connect the plug of the microphone to the INPUT1 connector.
(7) Set the INPUT LEVEL selector to MIC or MIC ATT.
(8) Select the channel to be used, using the REC CH SELECT switch. Used
30
upward, close the cover, and tighten the screw.
When the selector is set to MIC ATT, you can reduce the volume by about 20
dB. And set the +48V switch to ON.
channels according to the position of the REC CH SELECT switch are as
follows:
The position of the REC CH
SELECT switch
CH1•CH2
CH1
4
Audio input through The audio is recorded on
INPUT1
INPUT2
INPUT1
INPUT2
5
6
REC CH REC CH
SELECT SELECT
CH1•CH2
CH1
8 7
Channel 1/2
—
Channel 1
Channel 2
3
INPUT INPUT INPUT
LEVEL LEVEL +48V +48V LEVEL +48V
LINE ON LINE ON
MIC MIC
OFF OFF
MIC MIC
ATT ATT
INPUT1 INPUT2 INPUT2