Sony DVCAM DSR-PDX10 Operating Instructions Manual page 119

Audio dubbing
Adding audio on a recorded tape
Choose a connection described on the previous pages, and connect audio equipment or
microphone to your camcorder. Then follow the procedure below.
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording start point by pressing N . Then press X at the point
where you want to start recording to set your camcorder to the playback
pause.
(4) Press AUDIO DUB . The green
(5) Press X and start playing back the audio you want to record at the same time.
The new sound is recorded in channel3/channel4 during playback. While
audio is being recorded, the red
(6) Press x at the point where you want to stop recording.
AUDIO DUB
When you dub the recorded sound
You can adjust the recorded sound by using MIC LEVEL (p. 80). However, when the
camcorder is connected to the AUDIO/VIDEO jack, sound cannot be adjusted.
If you set the audio balance beforehand
You can monitor both the original sound and dubbed sound during the dubbing.
X indicator appears on the screen.
appears on the screen.
AUDIO DUB
119