Figure 4-6 Connecting The Fiber; Figure 4-7 Connecting The Ethernet Cable - Raisecom ISCOM2600 (B) Series Product Description

Raisecom
ISCOM2600 (B) Series Product Description

Figure 4-6 Connecting the fiber



Connecting Ethernet cable
Connect the Ethernet cable as below:
Step 1 Choose a proper length for the Ethernet cable according to cabling path, and make an Ethernet
cable accordingly.
Step 2 Insert the RJ45 connector of the Ethernet cable into the Ethernet interface of the ISCOM2600
series switch, and insert the other RJ45 connector of the Ethernet cable into the Ethernet
interface of the peer device, as shown in Figure 4-7.

Figure 4-7 Connecting the Ethernet cable

Connecting ground cable
Connecting the ground cable properly is an important guarantee for lightning
protection, shock proof, and anti-interference. When installing and using the device,
ensure that the ground cable is properly connected; otherwise, personnel injury or
equipment damage may occur.
Install the ground cable as below:
Step 1 Unscrew ground terminal counterclockwise, and remove the screws and washers.
Step 2 Sheathe the flat washer, ground OT terminal, and lock washer in sequence over the screw.
Figure 4-6 takes the 1000 Mbit/s SFP optical module for example. The connection
of the 10 Gbit/s SFP+ optical module is identical.
When the optical interface is idle, cover it with a dustproof cap to prevent dust and
dirt which may make the ISCOM2600 series switch work improperly.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
4 Device installation
59