Error Messages - Brother 885-U02 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Error messages

When erroneous operations are performed messages and advice on operation will be displayed on the LCD.
Follow what is displayed. If you press
displayed, the message disappears.
Error Message
or do the operation correctly while the error message is
There is a possibility that the data for the selected pattern is corrupted.
Either the start/stop button or the reverse/reinforcement stitch button
was pressed at a screen other than the sewing screen.
The start/stop button was pressed without connecting the foot controller
while the setting for adjusting the stitch width using the sewing speed
controller is set to "ON" (Refer to page 111).
You have selected a pattern for which width control cannot be used.
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
Press to cancel the twin needle setting. If the twin needle is
installed, replace it with a single needle. Then, select the pattern again.
Press to return to the previous screen.
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press the start/stop button
without rethreading the machine, the thread tension may be wrong or
the needle may break and cause injury.
You tried to create a design with too many points with the My Custom
Stitch function.
The machine is deleting a previously saved pattern while in embroidery
edit mode.
The start/stop button was pressed while the foot controller was
connected.
You tried to use the foot controller for embroidery.
You attempted to select a pattern after the USB media containing the
pattern has been disconnected, then reconnected.
The start/stop button was pressed before the editing was completed
with the My custom stitch function.
on the LCD was pressed when no card was inserted.
Probable Cause
Troubleshooting 201
5