Error Messages - Brother 882-W83 Operation Manual

ERROR MESSAGES

Below is an explanation of error messages. Refer to these when necessary (if you touch
correctly while the error message is displayed, the message disappears).
Error messages
Cannot change the configuration of the characters.
1
Cannot recognize the data for the selected pattern.
2
The data may be corrupted.
Change to a larger embroidery frame.
3
Failed to save file.
4
Includes a special pattern that cannot be saved to
external memory. Save the pattern in the machine's
5 memory.
Lower the presser foot lever.
6
Not enough available memory to save the data.
7
Delete some patterns or use a different media.
OK to recall and resume previous memory?
8
OK to separate the combined border pattern?
9
Pattern extends to the outside of embroidery frame.
10
Pattern extends to the outside of embroidery frame.
11 If you plan to add more patterns, rotate the pattern
combination.
Preventive maintenance is recommended.
12
Set the clock.
13
The bobbin thread is almost empty.
14
The bobbin winder safety device has activated. Is
15
the thread tangled?
Cause/solution
This message is displayed when there are too many characters and the
curved character configuration is impossible.
This message is displayed when there is a possibility that the data for the
selected pattern is corrupted.
This message is displayed when the machine is in embroidery mode and the
small frame is attached, and the selected pattern does not fit in the small
frame.
This message is displayed when no more images can be saved on the USB
media. In this case, delete a file from the USB media or use different USB
media.
This message is displayed when you try to save a copyright protected
pattern to USB media.
According to copyright laws, patterns that are illegal to reproduce or edit
cannot be saved to USB media. If this message displays, save the pattern in
the machine's memory.
This message is displayed when
while the presser foot lever is raised and the needle is lowered.
This message is displayed when the memory is full and the embroidery
pattern cannot be saved.
This message appears if the machine is turned off while embroidering, then
turned on again. Touch
(pattern position and number of stitches) when it was turned off. Follow the
procedure described in "If the Thread Breaks or the Bobbin Runs out of
Thread During Embroidering" on page 68 to align the needle position and
embroider the remainder of the pattern.
This message is displayed when rotating a saved combined pattern in the
embroidery screen.
This message is displayed when the machine is in embroidery mode, and the
character pattern combination is too large to fit in the embroidery frame.
This message is displayed when the machine is in embroidery mode and the
combined character pattern is too large for the embroidery frame. You can
rotate the pattern 90 degrees and continue combining characters.
This message is displayed when the machine needs to be maintained.
Once this message appears, it is recommended to take your machine to an
authorized Brother dealer or the nearest Brother authorized service center for
a regular maintenance check. Although this message will disappear and the
machine will continue to function once you touch
display several more times until the appropriate maintenance is performed.
This message appears when the time/date is not set. Set time/date.
(page 11)
This message is displayed when the bobbin thread is running out.
Although a few stitches can be embroidered when the "Start/Stop" button is
pressed, replace with a wound bobbin immediately. When embroidering,
, touch , remove the embroidery frame, and then replace
touch
the bobbin with one wound with plenty of embroidery bobbin thread.
If [Upper and Bobbin Thread Sensor] in the general settings screen of the
machine setting mode is set to [OFF], this message does not appear.
This message is displayed when the bobbin is being wound, and the motor
locks because the thread is tangled, etc.
ERROR MESSAGES
or do the operation
(Presser foot lifter button) is pressed
to return the machine to the condition
, the message will
5
117