Error Messages - Brother 882-W73 Operation Manual

ERROR MESSAGES

ERROR MESSAGES
Below is an explanation of error messages. Refer to these when necessary (if you touch
correctly while the error message is displayed, the message disappears).
Cannot change the configuration of the characters.
1
Cannot recognize the data for the selected pattern.
2
The data may be corrupted.
Change to a larger embroidery frame.
3
Data volume is too large for this pattern.
4
Failed to save file.
5
Includes a special pattern that cannot be saved to
external memory. Save the pattern in the machine's
6 memory.
Lower the presser foot lever.
7
Not enough available memory to save the data.
8
Delete some patterns or use a different media.
OK to recall and resume previous memory?
9
OK to separate the combined border pattern?
10
Pattern extends to the outside of embroidery frame.
11
Pattern extends to the outside of embroidery frame.
12 If you plan to add more patterns, rotate the pattern
combination.
Preventive maintenance is recommended.
13
Remove Dual Feed module from the machine.
14
Set the clock.
15
The "Start/Stop" button does not operate with the
16 foot controller attached. Remove the foot controller.
192
Error messages Cause/solution
This message is displayed when there are too many characters and the
curved character configuration is impossible.
This message is displayed when there is a possibility that the data for the
selected embroidery pattern is corrupted.
This message is displayed when the machine is in embroidery mode and the
small frame is attached, and the selected pattern does not fit in the small
frame.
This message is displayed when the stitch patterns you are editing take up
too much memory, or if you are editing too many stitch patterns for the
memory. For a combined pattern, reduce the number of patterns.
This message is displayed when no more images can be saved on the USB
media. In this case, delete a file from the USB media or use different USB
media.
This message is displayed when you try to save a copyright protected
pattern to USB media.
According to copyright laws, patterns that are illegal to reproduce or edit
cannot be saved to USB media. If this message displays, save the pattern in
the machine's memory.
This message is displayed when
while the presser foot lever is raised and the needle is lowered.
This message is displayed when the memory is full and the stitch pattern or
embroidery pattern cannot be saved.
This message appears if the machine is turned off while embroidering, then
turned on again. Touch
(pattern position and number of stitches) when it was turned off. Follow the
procedure described in "If the Thread Breaks or the Bobbin Runs out of
Thread During Embroidering" on page 141 to align the needle position and
embroider the remainder of the pattern.
This message is displayed when rotating a saved combined pattern in the
embroidery screen.
This message is displayed when the machine is in embroidery mode, and the
character pattern combination is too large to fit in the embroidery frame.
This message is displayed when the machine is in embroidery mode and the
combined character pattern is too large for the embroidery frame. You can
rotate the pattern 90 degrees and continue combining characters.
This message is displayed when the machine needs to be maintained.
Once this message appears, it is recommended to take your machine to an
authorized Brother dealer or the nearest Brother authorized service center for
a regular maintenance check. Although this message will disappear and the
machine will continue to function once you touch
display several more times until the appropriate maintenance is performed.
This message appears when you try to start embroidering with the dual feed
foot attached to the machine. Remove the dual feed foot before entering the
embroidery mode.
This message appears when the time/date is not set. Set time/date.
(page 14)
This message is displayed when the "Start/Stop" button is pushed to sew
Utility stitches or Character/Decorative stitches while the foot controller is
connected.
or do the operation
(Presser foot lifter button) is pressed
to return the machine to the condition
, the message will