Side Stand - KYMCO X-Town 300 ABS Service Manual

3. INSPECTION/ADJUSTMENT

SIDE STAND

Your scooter's side stand is not only necessary
when you park, but it contains an important
safety feature. This feature cuts-off the ignition
if you try to ride the scooter when the side stand
is down. Perform the following side stand
inspection.
INTERLOCK FUNCTION CHECK
Check the side stand ignition cut-off system,
1. Place the scooter on its center stand.
2. Put the side stand up and start the engine.
3. Lower the side stand. The engine should stop
as you put the side stand down.
＊
If the side stand system does not
operate as described, see your KYMCO
dealer for service.
Engine limit lever rubber gasket
Engine limit lever rubber gasket is made of
rubber,Deterioration and friction is normal,
so it needs inspction and replacement:
inspect every 10000km and replace every
30000km.
Removal
1. Remove the engine hanger fixing
nut,and remove the engine hanger bolt.
2. Remove the engine limit lever nut and
remove the rubber gasket ①.
3. Remove the limit lever and remove the
gasket ②.
Install the new gaskets in reverse order.
Torque:
Engine hanger nut torque:60-70 NM
Engine limit lever nut torque:40-50 NM
＊
1.The bumping points of gasket ① should
be placed towards the vehicle head.
X-Town300 ABS
Engine hanger bolt
① ②
②
①
3-12