Tps/Isc Reset - KYMCO X-Town 300 ABS Service Manual

13. FUEL INJECTION SYSTEM

TPS/ISC RESET

● If close or open the throttle grip randomly,
the ECU may record the incorrect TPS
when the ECU or the throttle body has
been reinstalled. It can cause hard to start
engine or idling speed is not smooth when
engine installation.
● ISC has a motor inside, which controls
ISC valve to obtain smooth idling speed.
The ECU may record the incorrect ISC
position during the engine speed isn't
working when the ECU or the throttle
body has been reinstalled. It can cause
engine stop, hard to start engine or rough
idling speed.
The throttle position sensor (TPS) and idle
air bypass valve (ISC) have to be reset when
throttle body, MAP, TPS, ISC or ECU has
been reinstalled.
TPS/ISC RESET PROCEDURE
1. Put the side stand up and engine stop
switch is at "RUN".
2. Turn the key to the OFF position.
3. Fully open the throttle and hold.
4. Turn the key to the ON position.
5. Release the throttle after waiting for eight
seconds.
6. Turn the key to the OFF position.
7. Waiting for two seconds
8. Turn the key to the ON position.
9. Waiting for two seconds
10.TPS and ISC have been reset
successfully.
If fail to reset, repeat the steps from 1 to 10.
13-13
X-town300 ABS