KYMCO X-Town 300 ABS Service Manual page 7

1. GENERAL INFORMATION
 Do not squeeze wires against the weld or
its clamp.
 After clamping, check each harness to
make sure that it is not interfering with any
moving or sliding parts.
 When fixing the wire harnesses, do not
make it contact the parts that will generate
high heat.
 Route wire harnesses to avoid sharp
edges or corners.
ends of bolts and screws.
 Route wire harnesses passing through the
side of bolts and screws.
projected ends of bolts and screws.
 Route harnesses so they are neither
pulled tight nor have excessive slack.
1-5
Do not pull
too tight！
Avoid the projected
Avoid the
No Contact
 Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge
or corner.
 When rubber protector cover is used to
protect the wire harnesses, it shall be
installed securely.
 Do not break the sheath of wire.
If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape or
replace it.
 When installing other parts, do not press
or squeeze the wires.
 After routing, check
harnesses are not twisted or kinked.
Do not press or
squeeze the wire
X-Town300 ABS
that the wire