Securam SCANLOGIC FPC-1808-II-MB Manual page 2

Operating the Electronic Lock
1. To unlock the safe, enter the existing six-digit user code (or fingerprint). Each
key press is confirmed with an audio and visual (LED flash) signal.
2. The lock will indicate a valid user code entry with a double signal. Within four
seconds, turn the handle or hand wheel clockwise to retract the locking bolts.
3. To lock the safe, turn the handle counter-clockwise until it stops to allow the
locking bolts to extend. Always test to see if the lock has re-engaged by turning
the handle clockwise.
Wrong Try Penalty
Every invalid user code entry is indicated by a triple signal. Entering five consecutive
invalid user codes will result in a five-minute delay period. The keypad will beep
every five seconds and the buttons on the keypad are not operable. Two beeps
indicate penalty time has expired and the beeping will stop, enter valid user code to
open the safe lock. At the end of the delay period, two incorrect user codes will
restart an additional five-minute delay period.
During the delay period, pressing any key or removing the battery will extend the
delay period for up to five minutes.
Changing User Code and Fingerprint
SecuRam® Electronic Lock user codes are set at the factory as 1-2-3-4-5-6 and
preset fingerprint. For security purposes, immediately change the user code to a
unique user code. The six-digit user code can be changed at any time. When
creating a new user code, avoid using personal data such as birth dates, street
numbers or phone numbers to keep valuables as secure as possible. Choose a
personal six-digit user code that can easily be remembered.
Always have the safe door open and locking bolts extended whenever
changing the user code or fingerprint.
User Code
1. Press "0" six times.
2. Enter existing six-digit user code, one beep.
3. Enter NEW six-digit user code, one beep.
4. Repeat NEW six-digit user code, two beeps.
5. Enter NEW six-digit user code once more to unlock the lock.
6. Test the lock several times with the NEW user code before closing and
locking the safe.
Fingerprint
1. Hold "+", one beep.
2. Place fingerprint four times, one beep each.
3. Two beeps confirm fingerprint addition.
4. Test the lock several times with the NEW fingerprint before closing and
locking the safe.