Table of Contents
Advertisement
INSTALLATION AND OPERATION MANUAL
1.0 Introduction
The NetWave® NW3 and NW4 from ComNet
transmission link that can be configured through the embedded User Interface as a Client or as an
Access Point. This point-to-multipoint model allows multiple Ethernet endpoints to be connected
to a central Access Point. Up to 15 endpoints can be linked to a central access point. The NW3
and NW4 support up to 95Mbps throughput due to MIMO technology. An easy to read LED array
displays unit operational status along with received signal strength ensuring optimal installation
and operation. The units are passive PoE (Power over Ethernet) powered or through a supplied
PoE injection module. The NW3 is FCC certified and the NW4 is ETSI, DFS and TPC certified.
This manual contains detailed information covering ComNet NetWave commercial grade 802.11n
wireless products. NetWave comes configured for either point to point or point to multipoint
applications.
This manual contains detailed operational and configuration information not covered in the quick
start guides.
This guide applies to the following models:
» NW3 – Commercial Multipoint, FCC Version, User Configurable
» NW4 – Commercial Multipoint, ETSI Version, User Configurable
» NWK3 – Commercial Point to Point Kit, FCC Version (Includes NWK3_AP and NWK3_CL)
» NWK4 – Commercial Point to Point Kit, ETSI Version (Includes NWK4_AP and NWK4_CL)
TECH SUPPORT: 1.888.678.9427
is a commercial grade wireless Ethernet
™
NW3/NW4
INS_NW(3,4)_REV– 06/10/13 PAGE 5
Advertisement
Table of Contents
Need help?
Do you have a question about the netwave NWK3 AP and is the answer not in the manual?