Table of Contents
Advertisement
INSTALLATION AND OPERATION MANUAL
6.0 Detailed Power Requirements
» Max peak current at 24VDC under a typical 60 second boot up: 180mA
» Max current at 24VDC after initial boot and radio lock/connection with less than 10Mb/s
Ethernet traffic throughput: 170mA
» Max current at 24VDC after initial boot and radio lock/connection with less than 30Mb/s
Ethernet traffic throughput: 180mA
» Max current at 24VDC after initial boot and radio lock/connection with less than 60Mb/s
Ethernet traffic throughput: 200mA
» Max current at 24VDC after initial boot and radio lock/connection with 95Mb/s Ethernet traffic
throughput: 220mA
7.0 Key Default Configurations
IP Address of Web Server
LAN Mode for Web Server
Web Server User ID
Web Server Password
Web Server Guest User ID
Webserver Guest Password guest
SSID
WPA Pre-shared Key
Channel-Frequency (AP)
Channel Spectrum Width
Long Range Parameters
NOTE: A Reset to defaults (performed on the ADMIN page) will erase all user configurations
including the factory set MAC lock on Point to Point (NWKx) models.
TECH SUPPORT: 1.888.678.9427
192.168.10.100 for NWKx_AP
192.168.10.101 for all other models
Static Addressing
admin
admin
guest
NetWave-1
12345678
Auto
20/40M
Enabled and defaulted to 1000m
NW3/NW4
INS_NW(3,4)_REV– 06/10/13 PAGE 11
Advertisement
Table of Contents
Need help?
Do you have a question about the netwave NWK3 AP and is the answer not in the manual?