Comnet netwave NWK3 AP Installation And Operation Manual page 40

INSTALLATION AND OPERATION MANUAL
» The last screen will confirm to reboot. Select Yes.
» Unit will reboot and the page will refresh after about 60 seconds.
» It is recommended that a factory reset be performed by selecting the Restore to Default
button at the bottom of the ADMIN page but may not be required. Consult ComNet tech
support for further detail on the particular upgrade or refer to the firmware release notes.
» The Firmware upgrade procedure is now complete.
9.7.2 ADMIN Page HOST NAME Section
Enter in the desired host name.
Remember to select Apply if any changes were made.
9.7.3 ADMIN Page ADMIN ACCOUNT Section
Remember to select Apply if any changes were made.
9.7.4 ADMIN Page READ-ONLY ACCOUNT Section
The read only account is for monitoring only with no configuration authorization
Enable Read-Only Account
Read-only Username
Password
Remember to select Apply if any changes were made.
TECH SUPPORT: 1.888.678.9427
Administrator Username Default is admin
Current Password
Enabled by Default
Default is guest
Default is guest
Default is admin
NW3/NW4
INS_NW(3,4)_REV– 06/10/13 PAGE 40