Comnet netwave NWK3 AP Installation And Operation Manual page 33

INSTALLATION AND OPERATION MANUAL
9.6.1 SYSTEM TOOLS Page STP Section
Enable STP
Root Priority
Root Hello Timer For setting STP hello times. Default is 2
Root Forward
Delay
Root Max Age
Remember to select Apply if any changes were made.
9.6.2 SYSTEM TOOLS Page PING WATCHDOG Section
The ping watchdog utility can be a useful tool if a node needs to be periodically rebooted.
Wireless equipment can sometimes require reboot to re-establish a connection if operating in
noisy environments
Enable Ping
Watchdog
IP Address to
ping
Ping Interval
Startup Delay
Failure Count to
Reboot
Remember to select Apply if any changes were made.
9.6.3 SYSTEM TOOLS Page AUTO-REBOOT Section
This can bet set to reboot a certain time every day or by a set number of hours. This is disabled by
default.
Remember to select Apply if any changes were made.
TECH SUPPORT: 1.888.678.9427
Not enabled by default
Allows the user to set priorities in each node used during the root
bridge selection process.
For setting STP forward delay. Default is 15
For setting STP maximum age timer. Default is 20
Not enabled by default.
Network address that the watchdog utility will ping.
Interval in seconds that the watchdog utility will send ICMP ping
requests out. Default is 5 seconds
One time delay after node is booted. Default is 60 seconds.
The number of successive ping failures before the node will initiate a
reboot.
NW3/NW4
INS_NW(3,4)_REV– 06/10/13 PAGE 33