Washing Results - IKEA TORSBODA Manual

FAULT
A different error code appears in
the display window.
E:01-00 to E:90-10

Washing results

FAULT
Tableware is not dry.
Plastic tableware is not dry.
CAUSE
A technical fault is present.
CAUSE
No rinse aid used or dosage set too
low.
Programme or programme option
has no drying phase, or the drying
phase is too brief.
Water collects in recesses of the
tableware or cutlery.
The combined detergent used has
a poor drying performance.
Extra Dry not activated to improve
drying performance.
Tableware removed too early or
drying process not yet ended.
Rinse aid used has a limited drying
performance.
Appliance door does not open auto-
matically at the end of the pro-
gramme
Not a fault. As plastic does not
store heat so well, it also does not
dry as well.
TROUBLESHOOTING
Press .
1.
Unplug the appliance or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Insert the mains plug of the appliance in a
4.
socket or switch on the fuse.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press ⁠ .
●
Turn off the water tap.
●
Pull out the mains plug.
●
Contact Customer Service and give the
●
error code.
TROUBLESHOOTING
Add "Rinse aid" → Page 18.
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 19
Select a programme with drying, e.g. intens-
●
ive, strong or ECO programme.
Some option buttons decrease the drying
result, e.g varioSpeed.
Position tableware at an angle where pos-
●
sible.
Use rinse aid to improve drying performance.
1.
Use a different combined detergent with a
2.
better drying performance.
Activate Extra Dry.
●
Wait until the programme ends.
1.
Only remove tableware 30 minutes after the
2.
programme has ended.
Use a name-brand rinse aid.
●
Eco products may have limited effectiveness.
Adjust the appliance door as described in the
●
installation instructions.
The door gap must be at least 70 mm -
100 mm.
No remedial action possible.
●
29