Table of Contents
Advertisement
FAULT
Water marks on plastic parts.
Wipeable or water-soluble coatings
are present inside the appliance or
on the door.
Stubborn white coatings are
present on tableware, inside the
appliance or the door.
Tea residue or lipstick marks on
tableware.
Coloured coatings (blue, yellow,
brown) that are difficult or im-
possible to remove are present in-
side the appliance or on stainless
steel tableware.
CAUSE
Due to laws of physics droplet
formation on plastic surfaces is un-
avoidable. After drying water marks
are visible.
Detergent substances are depos-
ited there. These coatings cannot
generally be removed with chemic-
als.
White coating is deposited in the
appliance interior.
Special salt dispenser is not
screwed tight.
Detergent substances are depos-
ited there. These coatings cannot
generally be removed with chemic-
als.
Hardness range is set incorrectly or
the water hardness is too high.
→ "Overview of water hardness set-
tings", Page 17
3in1/organic/eco detergent is not
effective enough.
Too little detergent is being used.
Washing programme selected too
weak.
Washing temperature is too low.
Too little detergent is being used or
is unsuitable.
Tableware has been precleaned too
intensely. The sensors chose a
weaker programme. Stubborn soil-
ing cannot be entirely removed.
The formation of films is due to
substances contained in vegetables
(cabbage, celery, potatoes, noodles,
etc.) or tap water (manganese).
The formation of films is due to
metal components on silver or alu-
minium tableware.
TROUBLESHOOTING
Select a more intensive programme.
●
→ "Overview of programmes", Page 13
Position tableware at an angle.
●
→ "Arrange tableware", Page 21
Use rinse aid.
●
→ "Rinse aid", Page 18
Set the water softening system higher.
●
→ "Setting the water softening system", Page 17
Change your "detergent" → Page 19.
●
Clean the appliance mechanically.
●
Set the water softening system correctly.
1.
→ "Setting the water softening system", Page 17
In most cases you will need to increase the
setting.
Change your detergent if required.
2.
Screw the special salt dispenser tight.
●
Change your "detergent" → Page 19.
●
Clean the appliance mechanically.
●
Set the Water softening system to the water
●
hardness or add special salt.
Set the Water softening system to the water
●
hardness and use separate detergents (pro-
prietary detergent, special salt, rinse aid).
Increase the amount of detergent used or
●
change "Detergent " → Page 19.
Select a more intensive washing programme.
●
→ "Overview of programmes", Page 13
Select a programme with a higher washing
●
temperature.
→ "Overview of programmes", Page 13
Use a suitable "Detergent " → Page 19 and fol-
●
low the manufacturer's instructions for the
amount to be used.
Only remove large remnants of food and do
●
not prerinse tableware.
Clean the appliance.
●
You can remove deposits with "Mechanical
cleaning" → Page 24 or a machine cleaning
product. It may not always be possible to
completely remove deposits but they are
harmless to health.
Clean the appliance.
●
You can remove deposits with "Mechanical
cleaning" → Page 24 or a machine cleaning
product. It may not always be possible to
completely remove deposits but they are
harmless to health.
31
Advertisement
Table of Contents
