Clean Wastewater Pump; Transportation, Storage And Disposal; Removing The Appliance; Protect Appliance From Frost - IKEA TORSBODA Manual

Hide thumbs Also See for TORSBODA:
Table of Contents

Advertisement

Clean wastewater pump

Large remnants of food or foreign bodies can block the
waste water pump. As soon as the rinsing water no longer
drains properly, the waste water pump must be cleaned.
WARNING
Risk of injury!
Sharp and pointed objects or fragments of glass may
block the waste water pump and cause injury.
Remove any foreign bodies carefully.
Disconnect the appliance from the power supply.
1.
Remove the top and bottom basket.
2.
Remove the filter system.
3.
Scoop out any water.
4.
Use a sponge if necessary.
Prise off the pump cover using a spoon and grip it by the
5.
crosspiece.

Transportation, storage and disposal

Transportation, storage and disposal
Transportation, storage and disposal

Removing the appliance

Disconnect the appliance from the mains power supply.
1.
Turn off the water tap.
2.
Detach the drainage connection.
3.
Detach the drinking water connection.
4.
Loosen any screws fastening the appliance to cabinet
5.
parts.
Remove the base panel if fitted.
6.
Pull the appliance out carefully, along with the hose be-
7.
hind it.

Protect appliance from frost

If there is a risk of frost where the appliance will be standing,
e.g. in a holiday home, empty the appliance completely.
Empty the appliance.
→ "Transporting the appliance", Page 35
Lift the pump cover inwards at an angle and remove.
6.
You can now reach the impeller with your hand.
a
Remove any remnants of food and foreign bodies in the
7.
area of the impeller.
Insert the pump cover
8.
1
The pump cover clicks into position.
a
Install the filter system.
9.
Insert the top and bottom basket.
10.

Transporting the appliance

To avoid damage to the appliance, empty it before trans-
porting.
Note: Always transport the dishwasher upright to prevent
residual water getting into the machine's controls and dam-
aging the appliance.
Remove tableware from the appliance.
1.
Secure loose parts.
2.
"Switch on the appliance." → Page 22
3.
Select the programme with the highest temperature.
4.
→ "Overview of programmes", Page 13
"Start the programme." → Page 22
5.
To drain the appliance, terminate the programme after
6.
approx. 4 minutes.
→ "Terminate programme", Page 22
"Switch off the appliance." → Page 22
7.
Turn off the water tap.
8.
To empty the residual water out of the appliance, detach
9.
the supply hose and let the water drain out.
and press down
⁠ .
2
35

Advertisement

Table of Contents
loading

Table of Contents