Postek TX Exp Series User Manual page 3

responsible for troubleshooting (according to POSTEK Warranty Clauses) only. In no event shall
POSTEK or the resellers involved be liable for any direct or indirect loss, including but not limited to
loss of business profits, business interruption, loss of business information, or other pecuniary loss.
Important Safety Instructions
Only qualified and trained service technicians should attempt to repair the printer.
•
Do not place the printer on or near a heat source.
•
Be sure that your power source matches the rating listed on the regulatory label on the back of the
•
printer. Be certain your power source is grounded.
To avoid getting an electric shock, do not use a worn or damaged power cord. If the power cord
•
becomes damaged or frayed, replace it immediately.
Do not insert anything into the ventilation slots or openings on the printer.
•
The printer should never be operated in a location where it can get wet. Personal injury may
•
result.
The printhead becomes hot while printing. To protect from damaging the printhead and risk of
•
personal injury, avoid touching the printhead.
To get increased printhead longevity and higher quality printouts, always use approved labels,
•
tags and thermal transfer ribbons. Approved supplies can be ordered from your POSTEK
authorized reseller.
Static electricity that accumulates on the surface of the human body or other surfaces can damage
•
or destroy the printhead or electronic components in this device. DO NOT touch the printhead or
the electronic components with bare hands.
• Place the printer on a flat, firm, solid surface.
Never operate in a high-temperature environment.
•
Turn off the power when not in use for extended periods.
•
Follow all recommendations and setup instructions included in this manual.
•