Cisco NCS 1001 Hardware Installation Manual page 32

Install Cisco NCS 1001
Install Two Post Slider into EIA/ANSI Rack
Figure 26: Two Post Slider Identification
1 Check for the left/right marking on the sliders.
a) Check whether the two post width is 5" OR 3". If the width is 5", use the default slider assembly for 5".
b) If the post width is 3", modify the right/left sliders as shown below.
Step 2
Prepare the two post slider.
Figure 27: Two Post Slider Preparation
Hardware Installation Guide for Cisco NCS 1001
28