Table of Contents
Advertisement
7.3
Combustion device
1.
Disconnect the main power and shut off the fuel supply.
!
Before obtaining access to electrical and fuel line components
all supply circuits must be disconnected.
Loosen nut (G) and lift fan housing off fi xing fl ange.
2.
Remove brake plate and electrode holder from the oil tube and clean.
3.
4.
Replace nozzle.
5.
Clean or replace brake plate.
6.
Check ignition electrodes, replace if necessary (see Technical data for
adjustment).
7.
Fit brake plate and electrode holder, (see Technical data for
adjustment).
Check fl ame tube and clean if necessary.
8.
9.
Install fl ame tube, be sure to install the drainage hole downwards (not
available on all fl ame tubes) so that any oil spills can drain out.
10.
Refi t fan housing and fi xing fl ange, lock with nut (G).
11.
Switch on the main power and open the fuel supply.
12.
Start burner and check/adjust combustion.
When servicing/replacing components that aff ect combustion,
!
fl ue gas analysis and soot test must be carried out following
installation.
30
Bentone
Use caution when
!
operating the burner,
surfaces may be hot.
NB: When soiled, always
!
replace nozzles with new
nozzles. Do not clean.
G
165 405 13
Advertisement
Table of Contents
