Prior To Operation - Sullair SRL-7.5MB User Manual

02250236-267 R02
Operation (continued)

2 Prior to Operation

● This section details the operation, activation and control methods of the SRL air compressor.
It is possible to select the operation control mode of the air compressor, change the control pressure
settings and set the automatic recovery from power failure. It is recommended that the selection of the
appropriate settings be based on the conditions in which the compressor will be used.
(In the case that "Customer Control Run mode" is selected, only the pressure control mode will be
available.)
How to select the control mode
Press the "Control Mode Switch" when the main power in ON and while the air compressor is not
running. The operation control mode will be changed as follows when you press the switch.
1. Operation Control Mode Setting
It is possible to change between Multi-Drive control mode and pressure control mode.
The operation of the air compressor can be controlled as followed.
(1) Multi-Drive Control Mode (Energy Saving mode)
Responding to the need of compressed air, the operation of SRL compressor heads is modified
automatically to keep the delivery pressure at around the necessary pressure (recovery pressure). This
operation allows the compressor to save energy by avoiding useless operation of compressor heads.
122
118
114
110
3 heads
(2) Pressure Control Mode
The operation of SRL compressor heads is controlled by Pressure Control Mode. All SRL compressor
heads are stopped simultaneously when the unit stops operating.
When starting the unit, the operation of each SRL compressor head starts one after another in
approximately 1.5 second increments to reduce the starting load.
M u l t i - D r i v e
Control Mode
Pressure Control
Mode
Pressure Control
2
1 head
heads
Subject to EAR, ECCN EAR99 and related export control restrictions.
Multi Drive Control
Maximum
Pressure
Recovery
Pressure
2 heads 1 head
14
2 heads