Sullair SRL-7.5MB User Manual page 32

02250236-267 R02
Maintenance and Inspection (continued)
20, 000 Hours and/or 8 Years Maintenance and Inspection Procedures ･ ･ ･ ･ 122PSIG Model
15, 000 Hours and/or 6 Years Maintenance and Inspection Procedures ･ ･ ･ ･ 145PSIG Model
Calling the local Sullair distributor is recommended for these maintenance and inspection items, including
the replacement of the scroll head (see page 21 and/or 22).
【122PSIG Model 】
● Eight (8) years or 20,000 hours is the recommended replacement period during normal operation.
Do not operate longer than 20,000 hours without replacing these components, as they will cause
damage to the air compressor and/or accidents.
【145PSIG Model 】
● Six (6) years or 15,000 hours is the recommended replacement period during normal operation.
Do not operate longer than 15,000 hours without replacing these components, as they will cause
damage to the air compressor and/or accidents.
Long Term Storage - SRL Air Compressor Out of Service for Over One Month
For additional long-term storage recommendation, consult Sulliar. For long-term storage of six months
or more, consult Sullair.
(1)Perform the following steps every month to prevent reduction in the grease life from moisture
accumulation:
- Idle the air compressor for longer than 30 minutes.
(2)Perform the following procedure every six (6) months to prevent rusting of the air compressor:
1. Operate the air compressor in a no-load state for 10 minutes.
2. Increase the pressure of the air compressor to verify correct operation (see page 19).
3. Operate the air compressor for another 10 minutes in a no-load state before stopping the air
compressor.
4. Completely drain the condensate in the air receiver.
(3) Storage Location
Store the air compressor in a room that meets all of the following criteria:
1. Minimal moisture
2. Dust-free
3. Out of direct sunlight
Subject to EAR, ECCN EAR99 and related export control restrictions.
WARNING
28