Digital Futronic Number Type Display (New For Ver 4.6); Setup; Normal Run Mode (S1, S2, S3, S4 Off) - Emerson Bettis 2000 Series User Manual

Section 4: Module Setup and Calibration
July 2019
4.2.2

Digital Futronic Number Type Display (New for Ver 4.6)

Digital Futronic firmware Ver 4.6 will display additional information on LED1 following flash
sequence shown in 4.2.1. On power up, LED1 will display Actuator Type which is currently
configured after it displays firmware version.
The LED flashes the actuator type as shown below before it turns on solid again for 2 seconds.
•
•
•
•
NOTE
LED1 flash sequence for Firmware Version and Digital Futronic type will display every
startup (or power cycle).
4.3

Setup

4.3.1

Normal Run Mode (S1, S2, S3, S4 OFF)

Turn off S1, S2, S3 & S4 for Normal Run Mode - Figure 4.
Figure 4
7
DF II, 2 Flashes
DF III, 3 Flashes
DF IV, 4 Flashes
DF VIII, 7 Flashes
Installation, Operation and Maintenance Manual
MAN-02-04-55-0735-EN Rev. 0
Module Setup and Calibration