Section 4: Module Setup and Calibration
July 2019
4.3.5
Set Modulation Delay (S1, S2 ON)
Press UP to select 3-Ph motor (delay = 2 sec) - Figure 8.
Press DOWN to select 1-Ph motor (delay = 12 sec) - Figure 8.
Figure 8
4.3.6
Set Default Position (S2 & S3 ON)
Press UP or DOWN to accept applied analog input (setpoint) as default position - Figure 9.
Figure 9
9
Installation, Operation and Maintenance Manual
MAN-02-04-55-0735-EN Rev. 0
Module Setup and Calibration