8.5.5 Self Diagnostic Test
Operation status can be tested by self diagnostic test by operating the sensors and switches following the
instruction on the screen.
Operation
(1) Confirm that the power is turned off.
(2) Turn the power on without loading the media.
(3) Press the [MENU] key to display the menu below.
(4) Press the POSITION (t) key (TEST) to display the menu below.
(5) Press the [4] key (DIAGNOSTICS) to display the menu below.
(6) Press the [1] key (DONE).
The first testing menu is displayed. And follow the instructions on the menu.
(7) Press the [1] key to continue to the next test, after you check the CAM lever sensor.
(8) The testing items are shown below.
1 Cam lever sensor
5 Font media sensor
9 [1] key
13 POSITION [u] key 14 POSITION [t] key 15 POSITION [q] key 16 POSITION [p] key
17 [ENTER] key
21 [CROSS CUT] key 22 [COPY] key
FC8000-UM-251-9370
2 Home sensor
6 X motor signal
10 [2] key
18 [CONDITION] key
3 Push roller sensor
7 Y motor signal
11 [3] key
19 [ORIGIN] key
23 [MENU] key
8-21
8. TROUBLESHOOTING
4 Rear media sensor
8 Tool height signal
12 [4] key
20 [FAST] key
24 [STOP] key