GRAPHTEC FC8000-60 Service Manual page 100

Error
Error Display
code
E01018
E01018 HARDWARE
Y POSITION ALARM
POWER OFF THEN ON
E01019
E01019 HARDWARE
XY POSITION ALARM
POWER OFF THEN ON
FC8000-UM-251-9370
Cause Verification item
Cutting Cutting conditions.
conditions do not
suit the cutting
medium.
Movement of the Is there anything
pen carriage is blocking the Y slider?
being obstructed.
Excessive load (1) Does the Y slider
is causing the move smoothly?
current to the
motor to exceed
the rated value.
(2) Is the Y flexible
cable securely
connected?
Or Is the Y flexible
cable broken?
Home sensor (3) Is the Y home
or sensor plate sensor plate position
adjustment. correct?
(4) Is the Y home
sensor position
correct?
Motor (5) Does the X-motor
turn smoothly?
Load on the Is there anything
motor was too blocking the X or Y
large. movement?
8-6
8. TROUBLESHOOTING
Solution
Lower the cutting
SPEED and/or the
cutting FORCE.
Turn off the plotter,
remove the obstacle,
then turn the plotter back
on.
No .....Check and adjust
the Y belt tension
and Y motor belt
tension.
Yes . ...Verify item (2).
No .....Connect it
securely.
Yes . ...Replace the Y
flexible cable if
defective.
No .....Check and adjust
the X-home
sensor position.
Yes . ...Replace the
X-home sensor if
defective
No .....Check and adjust
the X-home
sensor position.
Yes . ...Replace the
X-home sensor if
defective.
No .....Replace the
X-motor if
defective.
Yes . ...Replace the main
board if defective.
Turn off the plotter,
remove the obstacle,
then turn the plotter back
on.