Table of Contents
Advertisement
17. Performing continuous stitching
This sewing machine can perform continuous stitching which is capable of continuously sewing plural
sewing pattern data without lifting the presser foot. It is possible to automatically sew up to maximum 6
shapes in one cycle.
In addition, registration of as many as 20 data can be performed. Copy and use the data to fill the needs.
→ Refer to
"V-14. Copying sewing pattern" p.44
* It is necessary to change the parts from the state at that time of your purchase according to the
setting conditions.
(1) Selection of continuous stitching data
1) Set the mode to the input mode.
Under the input mode where SET READY LED
goes out, the continuous-sewing data selection is
enabled.
If the current mode is the sewing mode, press
READY key ❷
to the input mode.
Only under the input mode, the continuous-sew-
ing data selection is enabled.
2) Select continuous stitching.
Press ITEM SELECT key ❻
continuous-sewing screen A.
Press DATA CHANGE key ❼
continuous-sewing data No. B to be sewn.
3) Perform sewing.
When READY key ❷
state where the continuous-sewing data is select-
ed, SET READY LED lights up to show that the
sewing is enabled.
Continuous stitching data No. 1 only has been
registered at the time of your purchase. Howev-
er, sewing status cannot be obtained since the
sewing pattern has not been inputted. Perform
inputting of sewing pattern referring to (2) Method
of editing continuous stitching data on the next
page.
to change over the mode
to select the
to select the
is pressed in the
– 48 –
B
A
❷
❻
❼
Advertisement
Table of Contents
