Table of Contents
Advertisement
If you start the bobbin winder
independently (starting only the
bobbin winder without performing
sewing), remove the needle thread
from ❼ to as shown in the figure
given below so as to carefully
prevent the needle thread from
being entangled in the thread take-
up eyelet, etc.
4) Stop the sewing machine.
Once the bobbin is wound with the predetermined
amount of thread, bobbin winding lever ① is
released. Press PRESSER and WINDER key ❺
or depress the pedal to stop the sewing
machine. Then remove the bobbin and cut bobbin
thread with thread trimmer retaining plate ③ .
• Press PRESSER and WINDER key ❺
, and the sewing machine stops and returns to
the normal mode.
• Depress the pedal and the sewing machine
stops while the bobbin thread winding mode
stays as it is. Use this way when winding bob-
bin thread around plural bobbins.
(2) Adjusting the amount to be wound on
a bobbin.
To adjust the winding amount of the bobbin
thread, loosen setscrew ② and move the bobbin
winding lever ① to the direction of A or B. Then,
tighten setscrew ② .
To the direction of A : Decrease
To the direction of B : Increase
❼ Thread take-up eyelet
❽
– 30 –
❶
❻
❹
❸
❺
❾
❺
Advertisement
Table of Contents
