Table of Contents
Advertisement
No.
S010
Compensation of bar-tacking width, right
This item adjusts right side outer shape of bar-tack-
ing section in terms of overedging section. It is
corrected 1st and 2nd bar-tacking together.
Top of
Bottom
square
of square
type
type
S011
Compensation of bar-tacking width, left
This item adjusts left side outer shape of bar-tacking
section in terms of overedging section.
Top of
Bottom
square
of square
type
type
Taper bar-tacking offset, left
S012
This item sets length to form bar-tacking section of
taper bar-tacking shape.
Taper bar-tacking offset, right
S013
This item sets length to form bar-tacking section of
taper bar-tacking shape.
Eyelet shape length
S014
This item sets upper side length from center of eye-
let of eyelet shape.
S015
Number of stitches of eyelet shape
This item sets number of stitches in the upper 90˚ of
eyelet shape.
S016
Eyelet width
This item sets crossuise size of the inside of eyelet
shape. Actual needle entry point is the dimension to
which S004 Knife groove width, left is added.
Eyelet length
S017
This item sets lengthwise size of the inside of eyelet
shape.
Round type shape length
S018
This item sets upper length from the center of round
type shape.
Top of
Top of
round
Radial
type
type
Bottom
Bottom
of round
of radial
type
type
S019
Number of stitches of radial shape
This item sets number of stitches in the upper 90˚ of
radial shape.
Reinforcement of radial shape
S020
This item sets with/without reinforcement stitching of radial
shape.
*1 : Displayed according to the shape
*2 : Displayed when it is set to with edit. Refer to
*3 : Displayed when the function is selected.
Item
Bottom of
straight
bar-tacking
Bottom of
straight
bar-tacking
Top of
semilunar
type
Bottom of
semilunar
type
: With
: Without
"V-12. Method of setting sewing data with/without edit"
Setting range
-1.00 to 1.00
-1.00 to 1.00
0.00 to 3.00
0.00 to 3.00
1.0 to 10.0
1 to 8
1.0 to 10.0
1.0 to 10.0
1.0 to 5.0
1 to 8
–
– 39 –
Edit unit
Remarks
0.05 mm
–
0.05 mm
–
*1
0.05 mm
0.05 mm
*1
0.1 mm
*1
1
*1
0.1 mm
*1
0.1 mm
*1
0.1 mm
*1
1
*1
–
*1, *2
p.37.
Advertisement
Table of Contents
