Performing Continuous Stitching - JUKI LBH-1790 Instruction Manual

17. Performing continuous stitching

This sewing machine can perform continuous stitching which is capable of continuously sewing plural sewing
pattern data without lifting the presser foot. It is possible to automatically sew up to maximum 6 shapes in
one cycle.
In addition, registration of as many as 20 data can be performed. Copy and use the data to fill the needs.
/ Refer to 14. Copying sewing pattern
* It is necessary to change the parts from the state at tht time of your purchase according to the
setting conditions.
(1) Selection of continuous stitching data
1) Set the mode to the input mode.
When the back-light of LCD display q shows the
input mode in blue color, it is possible to select
continuous stitching data. When the back-light
shows the sewing mode in green color, press
READY key w
mode.
2) Call pattern selection screen.
Press PATTERN NO. key u
selection screen A is displayed.
Pattern No. B which is selected at present flashes
on and off.
3) Select continuous stitching.
Press ITEM SELECTION key !0
patterns which have been registered are changed
over and displayed in order. Cycle data No. and
continuous stitching data No. which have been
registered after the last registered pattern No. are
displayed. Here, select the continuous stitching data
No. which you desire to sew.
4) Perform sewing.
Press READY key w
continuous stitching data is selected, and the back-
light of LCD display q shows green and it is
possible to sew. Continuous stitching data No. 1
only has been registered at the time of your
purchase. However, sewing status cannot be
obtained since the sewing pattern has not been
inputted. Perform inputting of sewing pattern
referring to 2) Method of editing continuous
stitching data on the next page.
to change over to the input
, and pattern
, and
in the state that
w
B
A
u
38
q
!0