Table of Contents
Advertisement
13. Sewing data list
☆ Sewing data are those that can be inputted to 99 patterns from pattern 1 to 99 and can be inputted to
each pattern. The sewing machine has been set in the state that the data which is necessary to set "With/
without edit" cannot be selected at the time of your purchase. Change over the function to "With edit" if
necessary for the use. → Refer to
No.
Sewing shape
S001
Select a desired pattern shape from among 31 sewing shapes
stored in the sewing machine.
–
* Only 12 kinds of standard sewing shapes can be selected
at the time of your purchase. When increasing the kinds of
shapes, perform setting of K004 Sewing shape selection
level of memory switch data. → Refer to
switch data list"
S002
Cloth cut length
This item sets the length of cloth that is cut by cloth
cutting knife. However, in case of bar-tack shape (Nos.
27, 28, 29, and 30 of S001), sewing length is set.
By making effective U019 Function of plural mo-
tions of cloth cutting knife of memory switch data,
make the plural motions of knife by the knife size set
in the item U018 Cloth cutting knife size, and the
sewing product is cut. → Refer to
switch data list"
p.56.
Knife groove width, right
S003
This item sets the clearance between cloth cutting
knife and right parallel section.
Knife groove width , left
S004
This item sets the clearance between cloth cutting
knife and left parallel section.
S005
Overedging width, left
This item sets the overedging width of left parallel
section.
S006
Ratio of right and left shapes
This item sets enlargement/reduction ratio of right
side shape making the knife position as the center.
S007
Pitch at parallel section
This item sets sewing pitch of left and right parallel
sections.
2nd bar-tacking length
S008
This item sets length of bar-tacking on the front side.
Bottom
Bottom of
of square
straight
type
bar-tacking
S009
1st bar-tacking length
This item sets length of bar-tacking on the rear side.
Top of
square
type
"V-12. Method of setting sewing data with/without edit"
Item
Refer to
"II-2. Standard sewing
shape list"
p.3.
"V-22. Memory
p.56.
"V-22. Memory
Bottom
of taper
Setting range
1 to 31
3.0 to 120.0
-2.00 to 2.00
-2.00 to 2.00
0.10 to 5.00
50 to 150
0.200 to 2.500
0.2 to 5.0
0.2 to 5.0
– 38 –
p.37.
Edit unit
Remarks
1
–
0.1 mm
–
0.05 mm
–
0.05 mm
–
0.05 mm
–
1%
–
0.025 mm
–
0.1 mm
–
0.1 mm
–
Advertisement
Table of Contents
