Table of Contents
Advertisement
S A F E T Y G U I D E L I N E S
THIS FIXTURE IS COMPOSED OF SOPHISTICATED ELECTRONIC COMPONENTS. TO
GUARANTEE SMOOTH OPERATION, IT IS IMPORTANT TO FOLLOW ALL INSTRUCTIONS
AND GUIDELINES IN THIS MANUAL. ADJ PRODUCTS, LLC IS NOT RESPONSIBLE FOR
INJURY AND/OR DAMAGES RESULTING FROM THE MISUSE OF THIS FIXTURE DUE TO THE
DISREGARD OF THE INFORMATION PRINTED IN THIS MANUAL. ONLY QUALIFIED AND/OR
CERTIFIED PERSONNEL SHOULD PERFORM INSTALLATION OF THIS FIXTURE AND ONLY
THE ORIGINAL RIGGING PARTS INCLUDED WITH THIS FIXTURE SHOULD BE USED FOR
INSTALLATION. ANY MODIFICATIONS TO THE FIXTURE AND/OR THE INCLUDED MOUNTING
HARDWARE WILL VOID THE ORIGINAL MANUFACTURER'S WARRANTY AND INCREASE THE
RISK OF DAMAGE AND/OR PERSONAL INJURY. ONLY CERTIFIED PERSONNEL SHOULD
PERFORM INSTALLATION OF THIS FIXTURE.
•
PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED.
•
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT.
•
DO NOT ATTEMPT ANY REPAIRS YOURSELF; DOING SO WILL VOID YOUR
MANUFACTURER'S WARRANTY. DAMAGES RESULTING FROM MODIFICATIONS TO THIS
FIXTURE AND/OR THE DISREGARD OF SAFETY INSTRUCTIONS AND GUIDELINES IN
THIS MANUAL VOID THE MANUFACTURER'S WARRANTY AND ARE NOT SUBJECT TO ANY
WARRANTY CLAIMS AND/OR REPAIRS.
•
DO NOT PLUG FIXTURE INTO A DIMMER PACK!
•
NEVER OPEN THIS FIXTURE WHILE IN USE!
•
UNPLUG POWER BEFORE SERVICING FIXTURE!
•
NEVER TOUCH FIXTURE DURING OPERATION, AS IT MAY BE HOT!
•
KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!
•
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE!
•
RETINA INJURY RISK - MAY INDUCE BLINDNESS!
•
SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!
•
MINIMUM DISTANCE TO OBJECTS/SURFACES IS 6.6 FEET (2 METERS)
•
MAXIMUM AMBIENT TEMPERATURE IS 113° F (45°C). DO NOT OPERATE THE DEVICE
WHEN AMBIENT TEMPERATURE EXCEEDS THIS VALUE.
•
MINIMUM DISTANCE TO FLAMMABLE MATERIALS FROM THE SURFACE IS 1.6 FEET (0.5
METER).
•
DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow
approximately 60 minutes for the fixture to cool down before serving.
•
DO NOT shake fixture, and avoid brute force when installing and/or operating fixture.
•
DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power
cord connectors are damaged and do not insert into the fixture securely with ease. NEVER force
a power cord connector into the fixture. If the power cord or any of its connectors are damaged,
replace it immediately with a new one of the same power rating.
•
DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never blocked.
Allow approx. 6" (15cm) between fixture and other devices or a wall for proper cooling.
•
When installing fixture in a suspended environment, always use mounting hardware that is no less
than M10 x 25 mm, and always install fixture with an appropriately rated safety cable.
•
Always disconnect fixture from main power source before performing any type of service and/or
cleaning procedure.
•
Only handle the power cord by the plug end. Never pull out the plug by tugging the wire portion of
the cord.
•
During the initial operation of this fixture, a light smoke or smell may emit from the interior of the
fixture. This is a normal process and is caused by excess paint in the interior of the casing burning
off from the heat associated with the lamp and will decrease gradually over time.
•
Consistent operational breaks will ensure fixture will function properly for many years.
•
ONLY Use original packaging and materials to transport the fixture in for service.
8
Advertisement
Table of Contents
