Table of Contents
Advertisement
S A F E T Y G U I D E L I N E S
This fixture is a sophisticated piece of electronic equipment. To guarantee smooth operation, it is
important to follow all instructions and guidelines in this manual. ADJ is not responsible for injury and/
or damages resulting from the misuse of this fixture due to the disregard of the information printed in
this manual. Only qualified and/or certified personnel should perform installation of this fixture and only
the original rigging parts (omega brackets) included with this fixture should be used for installation. Any
modifications to the fixture and/or the included mounting hardware will void the original manufacturer's
warranty and increase the risk of damage and/or personal injury.
PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED.
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT. DO NOT ATTEMPT
ANY REPAIRS YOURSELF, AS DOING SO WILL VOID YOUR MANUFACTURER'S
WARRANTY. DAMAGES RESULTING FROM MODIFICATIONS TO THIS FIXTURE
AND/OR THE DISREGARD OF SAFETY INSTRUCTIONS AND GUIDELINES IN THIS
MANUAL VOID THE MANUFACTURER'S WARRANTY AND ARE NOT SUBJECT TO
ANY WARRANTY CLAIMS AND/OR REPAIRS.
DO NOT PLUG FIXTURE INTO A DIMMER PACK!
NEVER OPEN THIS FIXTURE WHILE IN USE!
DISCONNECT FIXTURE FROM POWER BEFORE SERVICING!
NEVER TOUCH THE FIXTURE DURING OPERATION, AS IT MAY BE HOT!
KEEP FLAMMABLE MATERIALS AWAY FROM THE FIXTURE!
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE!
RETINA INJURY RISK - MAY INDUCE BLINDNESS!
SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!
MAXIMUM EXTERNAL SURFACE TEMPERATURE: 185° F (85° C)
MAXIMUM AMBIENT TEMPERATURE: 104° F (40° C)
• DO NOT TOUCH the fixture housing during operation.
•
Turn OFF the power and allow approximately 15 minutes for the fixture to cool down before
serving.
• DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power
cord connectors are damaged and do not insert into the fixture securely with ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its connectors
are damaged, replace it immediately with a new one of similar power rating.
• DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never
blocked. Allow approx. 6" (15cm) between fixture and a wall for proper cooling.
•
When installing fixture in a suspended environment, always use mounting hardware that is at
least M10 x 25 mm, and always install fixture with an appropriately rated safety cable.
•
Always disconnect fixture from main power source before performing any type of service and/or
cleaning procedure.
•
Only handle the power cord by the plug end, and never pull out the plug by tugging the wire
portion of the cord.
•
During the initial operation of this fixture, a light smoke or smell may emit from the interior of
the fixture. This is a normal process and is caused by excess paint in the interior of the casing
burning off from the heat associated with the lamp and will decrease gradually over time.
•
Consistent operational breaks will ensure fixture will function properly for many years.
•
In the event that the fixture needs to be returned for servicing, use only the original packaging
and materials to transport the fixture.
6
Advertisement
Table of Contents
