Fire Alarm System; In Case Of Fire Alarm; Silencing A Fire Alarm - Honeywell VISTA-128FBPT User Manual

Fire Alarm System

Your fire alarm system (if installed) is on 24 hours a day, providing
continuous protection. In the event of an emergency, the smoke and heat
detectors automatically send signals to your Control, triggering a loud
interrupting sound from the keypad and the optional exterior sounders.
FIRE appears at your keypad and remains on until you silence the alarm.

In Case Of Fire Alarm

1. Should you become aware of a fire emergency before your detectors sense
the problem, go to your nearest keypad and manually initiate an alarm
by pressing the panic key assigned as FIRE emergency (if programmed
by the installer) and hold down for at least 2 seconds.
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify your
local Fire Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the alarm.
The descriptor of the zone(s) in alarm appears at the keypad.

Silencing a Fire Alarm

1. Silence the keypad by entering your code and pressing the OFF key.
This may or may not also silence the fire bells. A second entry may be
required, depending on system programming. To clear the display, enter
your code and press the OFF key again
2. If the keypad does not indicate a READY condition after the second OFF
sequence, press the READY key to display the zone(s) that are faulted.
Be sure to check that smoke detectors are not responding to smoke or
heat producing objects in their vicinity.
eliminate the source of heat or smoke.
3. If this does not remedy the problem, there may still be smoke in the
detector. Clear it by fanning the detector for about 30 seconds.
4. You can clear the display by entering your code + the OFF key.
– 58 –
National Security Systems (800)457-1999
http://nationalsecuritysystems.com
Should this be the case,