Resetting Your System After A Fire Alarm - Honeywell LYNX Touch 7000 Owner's Manual

After the fire department has told you it is safe to reenter your home, use the following
procedure to reset your system. See page 10 under location of fire protection to see if
you have 2-wire or 4-wire smoke detectors.
For System with Two-Wire Smoke Detectors
What You Do
Enter your
passcode
Press
For System with Four-Wire Smoke Detectors
What You Do
Enter your
passcode
Press
Press down arrow
key to scroll to
"FIRE RESET".
Press the number
corresponding to
"FIRE RESET".
IMPORTANT
After you have reset your system, if the audible alarm starts again, check
each of your smoke detectors to determine which one activated the alarm.
(Look for a steady red light.) Fan the detector for 20 to 25 seconds to clear it
of possible trapped smoke. Then enter your passcode again and respeat the
process outlined above. If the alarm continues, follow the procedure outlined
in the Emergency System Shutoff section and call for service.

Resetting Your System after a Fire Alarm

What You See
OK to reset
Smoke Detectors
(Current mode)
What You See
OK to reset
Smoke Detectors
1– AWAY ALL ON
2– AWAY PARTIAL
6– SYSTEM TEST
7– FIRE RESET
THE SMITH'S
55
What Happens
Audible alarm stops. The
system prompts you to press
OK to reset the smoke
M14238
detectors.
The security panel and smoke
detectors reset.
What Happens
Audible alarm stops. The system
prompts you to press OK to
reset the smoke detectors. This
M14238
will not reset four-wire smoke
detectors.
The mode menu displays the
first two selections.
M6943
The display scrolls to reveal
more selections.
M14239
The four-wire smoke detectors
are reset and the system returns
to the normal mode.
M6942
74-2760—1