Security Codes And Authority Levels; General Information; Duress Code; Quick Arming - Honeywell VISTA-128FBPT User Manual

Security Codes and Authority Levels

General Information

At the time of installation, you were assigned an authority level and a
personal 4-digit security code, known only to you and yours. The security
code must be entered when arming and disarming the system. The authority
level defines the system functions that you can perform.
As an additional safety feature, other users that do not have a need to know
your code can be assigned different security codes, and each user can be given
a different authority level. Users are identified by "user numbers", which are
assigned when assigning a user's security code.
All codes can be used interchangeably when performing system functions
within the limits of each code's authority level (a system armed with one
user's code can be disarmed by another user's code), with the exception of the
Operator Level C code. See Authority Levels paragraph on the following page
for details regarding authority levels.

Duress Code

This feature is intended for use if you are forced to disarm or arm the system
under threat. When used, the system will act normally, but can silently
notify the central station of your situation, if that service has been provided.
The duress code is pre-assigned by the installer during installation (authority
level 6).
IMPORTANT: This code is useful only when the system is connected to a
central station.

Quick Arming

Note: If "Quick Arming" was programmed by the installer, the [#] key can be
pressed in place of the security code when arming the system. The security
code must always be used to disarm the system, however.
– 16 –
National Security Systems (800)457-1999
http://nationalsecuritysystems.com