Using #77 Instant Activation Mode - Honeywell VISTA-128FBPT User Manual

Using #77 Instant Activation Mode

The #77 Instant Activation Mode is used to activate outputs, bypass zones,
etc. immediately upon exiting the #77 Mode. The actions that may be
activated are relay commands, arm/disarm commands, zone bypassing
commands, and open/close access conditions.
Relay Commands
Action Code
01 Relay On
02 Relay Off
03 Relay Close for 2 seconds
04 Relay Close XX minutes*
05 Relay Close YY seconds*
06 Relay Group On
07 Relay Group Off
08 Relay Group Close for 2 seconds
09 Relay Group Close XX minutes *
10 Relay Group Close YY seconds *
* Check with your installer for the amount of time.
Arm/Disarm Commands
Activation times 1 (Beginning), 2 (End), and 3 (During) are the only valid
choices for automatic arming and disarming functions.
"During" can be used to arm or disarm the control for a specific time only.
For example, if "during" is selected with Arm-STAY, the system will
automatically Arm-STAY at the beginning of the window and automatically
disarm at the end of the window.
Action Code
20 Arm-STAY
21 Arm AWAY
22 Disarm
23 Force Arm STAY (Auto-bypass faulted zns)
24 Force Arm AWAY (Auto-bypass faulted zns)
25 Arm INSTANT
26 Arm MAXIMUM
– 52 –
National Security Systems (800)457-1999
http://nationalsecuritysystems.com
Action Specifier
Relay #
Relay #
Relay #
Relay #
Relay #
Relay Group #
Relay Group #
Relay Group #
Relay Group #
Relay Group #
Action Specifier
Partition(s)
Partition(s)
Partition(s)
Partition(s)
Partition(s)
Partition(s)
Partition(s)