Fire Alarm System - Honeywell LXL-1000 User Manual

Hide thumbs

Table Of Contents

Table of Contents

U U U U L L L L

Fire Alarms and

Clearing Memory

Smoke Detector

www.PDF-Zoo.com

THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS

The LXL-1000/1010 is not intended for use in UL Fire installations

General

Your fire alarm system (if installed) is on 24 hours a day, for continuous

protection. In the event of an emergency, the strategically located smoke and

heat detectors will sound their alarms and automatically send signals to your

system, triggering a loud, interrupted pulsed sound* from the Keypad(s) and

any external sounders. A FIRE message will appear at your Keypad and

remain on until you silence the alarm (see below for silencing fire alarms).

* Temporal pulse sounding is produced for Fire alarms, as follows:

3 pulses–pause–3 pulses–pause–3 pulses–pause. . . , repeated.

F I R E 0 1 M A S T E R

B E D R O O M

ALPHA DISPLAY KEYPAD

Silencing

1. You can silence the alarm at any time by pressing the OFF key . To clear

the display, enter your code and press the OFF key again (to clear Memory

of Alarm).

2. If the Keypad's FIRE display does not clear after the second OFF sequence,

of Alarm

smoke detectors may still be responding to smoke or heat producing objects

in their vicinity. Investigate, and should this be the case, eliminate the

source of heat or smoke.

3. If this does not remedy the problem, there may still be smoke in the

detector. Clear it by fanning the detector for about 30 seconds. When the

problem has been corrected, clear the display by entering your code and

pressing the OFF key.

Depending on the type of smoke detectors in your system, it may be

necessary to "reset" the smoke detectors after a fire alarm has been turned

Reset

off. Check with your installer. This "reset" is accomplished at a keypad, as

follows:

Enter User Code (except "arm only" user), then press the [1] key.