Table of Contents
Advertisement
SuperWorkstation SYS-5039A-i User's Manual
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
prevent compatibility issues, only use components that match the specifications and part
numbers.
Installation or replacement of most components require that power first be removed from the
system.
3.1 Removing Power
Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non hot-swap components or when replacing
a non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has completely shut-down, disconnect the AC power cords from the
power strip or outlet.
3. Disconnect the power cords from the power supply modules.
3.2 Accessing the System
The SC732 chassis features two removable side covers, allowing access to the interior.
Removing the Side Covers
1. Remove the two screws securing the left side cover to the chassis.
2. Slide the left cover toward the rear of the chassis.
3. Lift the left cover from the chassis.
4. Remove the three screws securing the right side cover to the chassis.
5. Slide the right cover toward the rear of the chassis
6. Lift the right cover from the chassis.
Chapter 3
16
Advertisement
Table of Contents
