Connecting Load And Auxiliary Power - Advanced Energy Thyro-PX User Manual

®
Advanced Energy
c. Strip 7 mm (0.28") of insulation from each conductor.
3. Connect each conductor to the plug-in, screw-terminal block.
4. Plug the block into the power controller.
5. Connect the cable shield to the shield clamp.
Related Links
• "Analog and Digital I/O" on page 4‑4

Connecting Load and Auxiliary Power

DANGER:
RISK OF DEATH OR BODILY INJURY. Follow your local jurisdiction
requirements for lockout/tagout prior to connecting or disconnecting all input
power sources and output connections.
DANGER:
RISQUE DE MORT OU DE BLESSURES. Respectez les exigences de votre
juridiction locale en matière de verrouillage/étiquetage avant de connecter ou
de déconnecter toutes les sources d'alimentation d'entrée et les connexions
de sortie.
WARNING:
This device must be installed so that the output power connection is
inaccessible to the user.
AVERTISSEMENT:
Le dispositif doit être installé de façon à ce que l'utilisateur ne puisse accéder
à la connexion de puissance de sortie.
TO CONNECT LOAD AND AUXILIARY POWER
1. Press on the retaining clip on the front of the unit(s), and slide the plastic
cover(s) forward to remove.
2. Verify that the Protective Earth ground conductor is connected.
3. Connect each phase of the mains supply to the mains terminal (L1, L2, L3).
☞
Important
a. Use the screw size specified in
b. Tighten to the torque specified in
57010241-00B
A clockwise rotating field is required.
Installation, Setup, and Operation
®
Thyro‑PX
Table 5‑1.
Table 5‑2.
DC Power Controller
5‑7