Configuring Outgoing Call Authority Control Service; Abbreviated Dialing Service; Introduction To Abbreviated Dialing Service - H3C XE 200 User Manual

User Manual
H3C XE 200/2000 IP PBX G-Remote

5.5.3 Configuring Outgoing Call Authority Control Service

Table 5-7 Configure the outgoing call authority control service
Step
1
2
—
Return to

5.6 Abbreviated Dialing Service

5.6.1 Introduction to Abbreviated Dialing Service

The abbreviated dialing service uses two-digit abbreviated numbers to replace
specified called numbers for easy dialing. To call a specified number, a subscriber only
needs to dial the corresponding two-digit abbreviated number.
Configuration
task
1)
Configure the
subscriber role
for a
2)
subscriber
Command: subscriber-role (outgoing call
authority control service view)
Select [System View/Location
Server/Gateway/the gateway where the
subscriber to be configured is
located/Subscriber/the subscriber to be
Enable/disable
configured] in the navigation tree, and
the outgoing
Select [Call Out Limit] in the configuration
call authority
window to enable the outgoing call
control service
authority control service.
for a
subscriber
Clear this check box to disable the
outgoing call authority control service.
Command: srv-switch cba (subscriber
number view)
Configure
other call Refer to
services
XE IP PBX Configuration
Chapter 5 Call Service Configuration
Description
Select [System
Server/Gateway/the gateway where the
subscriber to be
located/Subscriber/the subscriber to be
configured] in the navigation tree.
Set the subscriber role correctly in the
configuration window.
Call Service Overview.
Overview.
5-10
Remarks
View/Location
configured is
Required
Required
Optional